LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Body - Interior & Exterior) >> Seats, Front >> Seat >> Installation

Seats, Front: Seat: Installation

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
multimedia:A supplement to the article is available.
NOTE:

The bolts may be a Mortorq® bolt and require a Mortorq® tool bit for removal and installation.

INSTALLATION

  1. Position the front seat into the vehicle. Route and connect the wire harness connectors.
  2. Install all the seat bolts loosely, then tighten the front seat bolts to the proper. Refer to TECHNICAL SPECIFICATIONS .
  3. Install the seat bolt cover.
  4. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
  5. The supplemental restraint system verification test procedure should be performed following service of any supplemental restraint system component. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals