Glove Box, Instrument Panel: Removal

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of CHRYSLER GROUP, LLC

Open the glove box door and release the support arms (2) by pressing down on them, and pulling out on the glove box door.
Release the damper arm (1) and remove the glove box door.

Courtesy of CHRYSLER GROUP, LLC
Remove the screws (1) at the front of the glove box.
Remove the fasteners and the silencer panel, below the glove box.

Courtesy of CHRYSLER GROUP, LLC
Remove the push fastener (1) and the floor duct (2), below the glove box.

Courtesy of CHRYSLER GROUP, LLC
Remove the screws (1) located under the glove box.
NOTE:
Position necessary harnesses to access screws
Disconnect the glove box light wire harness connector (2).

Courtesy of CHRYSLER GROUP, LLC
Release the side retaining clips and remove the glove box (1) from the instrument panel.