Glove Box, Instrument Panel: Installation
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Position the glove box (1) into the instrument panel and seat the retaining clips fully.
- Install the screws (1) at the front of the box.
- Install the lower glove box screws (1).
- Connect the glove box light wire harness connector (2).
- Install the floor duct (2) and push fastener (1), below the glove box.
- Install the silencer panel, below the glove box.
- Install the glove box door (3) onto the hinge and connect the damper arm (1).
- Insert the support arms (2) into the glove box slots. Check glove box door for proper operation.