Section 22 (Body - Interior & Exterior): Exterior: Nameplate: Removal
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
FRONT/SIDE NAMEPLATES
| 1 - JEEP |
| 2 - TRAIL RATED |
| 3 - CHEROKEE |
REAR NAMEPLATES
| 1 - LIMITED, SPORT, LONGITUDE, NORTH, TRAIL HAWK |
| 2 - JEEP |
| 3 - 4x4, ECO DIESEL |
NOTE:
Exterior nameplates are attached to body panels with adhesive tape.
- Apply a length of masking tape on the body, parallel to the top edge of the nameplate to use as a guide, if necessary.
- If temperature is below 21°C (70°F) warm emblem with a heat lamp or gun. Do not exceed 52°C (120°F) when heating emblem.
- Insert a plastic trim stick or a hard wood wedge behind the emblem to separate the adhesive backing from the body.
- Clean adhesive residue from body with MOPAR® Super Kleen solvent or equivalent.