Molding, Outer Belt: Removal
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Lower the door glass fully.
- Remove the mirror, Refer to MIRROR, OUTSIDE REARVIEW, GLASS, REMOVAL .
- Separate the rear of the glass run weatherstrip (1) from the door window frame and position aside.
- Using special tool (special tool #9093, Remover, Belt Moldings) (1) between belt molding and glass, push down on outer belt molding (2) and rotate upper part of tool outward from vehicle approximately 6 - 8 cm (2.5 - 3 in.) then lift up on molding to disengage from locking tabs.
- Remove the belt molding (1) from the glass opening flange (2).