Prop Assembly, Power: Removal

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Do not use any type of pliers on the machined surface of the gas prop to assist in supporting the hood or decklid. Use a proper device for support, or the help of an assistant.

Courtesy of CHRYSLER GROUP, LLC

Open and support the liftgate with a suitable prop or block.

Courtesy of CHRYSLER GROUP, LLC
Locate the mount (2) for the liftgate strut (3) on the liftgate (1).

Courtesy of CHRYSLER GROUP, LLC
Using a small flat bladed tool (3), or equivalent, release the retaining clips (2) while pulling the ball socket (1) away from the ball stud (4).

Courtesy of CHRYSLER GROUP, LLC
Remove the rubber grommet (1) to gain access to the liftgate strut (3) connector.

Courtesy of CHRYSLER GROUP, LLC
Disconnect the connector (2).
Remove the strut (1) from the vehicle.