LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Lamps/Lighting - Exterior (Service Information)) >> Lamp, License Plate >> Removal >> Bulb

Lamp, License Plate: Removal: Bulb

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0144690Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the license plate lamp from the rear fascia.
  3. Pull the base of the bulb (2) straight out of the socket (1).
scientia non olet · About LEMON Manuals