Lamp, Fog: Removal: Bulb
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Raise the vehicle until the wheel well access cover for the fog lamps can be reached comfortably.
- Twist the top rotational button until the top of the cover releases. Rotate the cover 180° allowing full access to the back of the fog lamp and bulb assembly.
- Disconnect the wire harness connector from the back of the fog lamp assembly.
- Remove the four fasteners (2) securing the lamp (1) to the lower front fascia.
- Pull the fog lamp through the access hole.
- Depress on the two points of the bulb socket (3) to release and remove the bulb socket from the fog lamp assembly.
- Remove the bulb from the bulb socket.