LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Lamps/Lighting - Exterior (Service Information)) >> Lamp, Fog >> Installation >> Lamp

Lamp, Fog: Installation: Lamp

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Insert the fog lamp through the access panel in the wheel well.
  2. Line up the lamp with the screw holes and secure the lamp using all four fasteners.
  3. Attach the harness connector to the back of the lamp assembly.
  4. Turn the access cover until the cover is lined up and the button can be turned to secure the cover to the wheel well.
  5. Lower the vehicle.
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
scientia non olet · About LEMON Manuals