Lamp - Center
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- To remove and replace a bulb, use a trim stick to pop loose the lens covering the defective bulb. Remove bulb and replace.
- To remove the entire dome lamp assembly, Insert a trim stick between the lamp housing and the headliner to pry the dome lamp assembly loose.
- Disconnect the harness from the back of the dome lamp.