LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Lamps/Lighting - Interior (Service Information)) >> Lamp, Cargo >> Removal >> Bulb

Lamp, Cargo: Removal: Bulb

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0153297Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the cargo lamp from the vehicle. Refer to LAMP, CARGO, REMOVAL .
  3. Disengage the end of the lamp lens (3) with the latch feature from the retention pin on each side of the lamp hood (1).
  4. Pivot the lens up from over the hood.
  5. Unfold the lamp hood from the lamp socket (4) far enough to access the bulb (2).
  6. Pull the base of the bulb straight out of the socket.
scientia non olet · About LEMON Manuals