Diagnostic Test

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DTC

With the scan tool, read Body Control Module (BCM) DTCs and record on the repair order.
Record the Environmental Data and any DTCs.
With the scan tool, erase DTCs.
Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
With the scan tool, read BCM DTCs.
Did the DTC return?

Yes
- Perform the PROGRAM THE BCM (Body Control Module) procedure. Refer to BODY CONTROL MODULE PROGRAMMING .
No
- Test complete. The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .