Diagnostic Test

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR ACTIVE DTCS

With the scan tool, record and erase the DTCs.
Cycle the ignition off, wait 10 seconds, then cycle the ignition on.
If possible, operate the liftgate several times.
With the scan tool, read the Active DTCs.
Does the scan tool display; B195F-11-POWER LIFTGATE CHIME CONTROL - CIRCUIT SHORT TO GROUND?

Yes
- Replace the Power Liftgate Module in accordance with the Service Information. Refer to MODULE, POWER LIFTGATE CONTROL (PLGM), REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and poor pin fit.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .