Diagnostic Test

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

VERIFY THE DTC IS ACTIVE
1. Turn the ignition on.
2. With the scan tool, record and erase DTCs.
3. Cycle the ignition from off to on.
4. With the scan tool, read DTCs.
  Is the DTC active at this time?
  
  Yes
  - Go To 2
  No
  - Go To 5
CHECK FOR BODY CONTROL MODULE (BCM) DTCS
1. With the scan tool, read BCM DTCs.
  Are there any BCM CAN Bus DTCs present?
  
  Yes
  - Perform the appropriate diagnostic procedure. Refer to BODY CONTROL MODULE (BCM) - DIAGNOSTIC CODE INDEX .
  No
  - Go To 3
CHECK FOR DRIVE TRAIN CONTROL MODULE (DTCM) DTCS
1. With the scan tool, read DTCM DTCs.
  Are there any DTCM DTCs present?
  
  Yes
  - Perform the appropriate diagnostic procedure. Refer to DIAGNOSTIC CODE INDEX, DTCM .
  No
  - Go To 4
CHECK OTHER MODULES FOR DTCS
1. With the scan tool, read DTCs.
  Are there any other modules reporting implausible communication DTCs against the DTCM?
  
  Yes
  - Replace the Drive Train Control Module (DTCM) in accordance with the Service Information. Refer to MODULE, DRIVETRAIN CONTROL (DTCM), REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Using the schematics as a guide, check the Park Assist Module (PAM) pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the Park Assist Module (PAM) in accordance with the Service Information.
    Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE WIRING AND CONNECTORS
1. The conditions necessary to set the DTC are not present at this time.
2. Using the schematics as a guide, inspect the wiring and connectors specific to this module. Wiggle the wiring and connectors while checking for shorted and open circuits.
3. Check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
4. Check Service Bulletins for any possible causes that may apply.
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Test complete.