Diagnostic Test
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR AN ACTIVE DTC
- Turn the ignition on.
- With the scan tool, create a Vehicle Scan Report and attach it to the repair order.
- Operate the Mirror Fold Switch several times.
- Wait 30 seconds.
- With the scan tool, read DDM DTCs.
Is the DTC active?
Yes
- Replace the Window/Door Lock Switch in accordance with the Service Information. Refer to SWITCH, LOCK, REMOVAL .
- Perform BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Go To 2
- INSPECT DRIVER DOOR SWITCH ASSEMBLY FOR DAMAGE
- Turn the ignition off.
- Inspect the Driver Door Switch Assembly for damage.
Is the switch assembly damaged?
Yes
- Replace the Window/Door Lock Switch in accordance with the Service Information. Refer to SWITCH, LOCK, REMOVAL .
- Perform BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Go To 3
- INSPECT FOR OBJECT OR SUBSTANCE CAUSING MIRROR FOLD SWITCH TO STAY OR STICK IN A PUSHED POSITION
- Inspect the Mirror Fold switch for anything that would cause it to stay or stick in a pushed position.
Is anything present that would cause the Mirror Fold switch to stay or stick in a pushed position?
Yes
- Replace the Window/Door Lock Switch in accordance with the Service Information. Refer to SWITCH, LOCK, REMOVAL .
- Perform BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension and repair as necessary. If no problems are found, test complete.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- Inspect the Mirror Fold switch for anything that would cause it to stay or stick in a pushed position.