Diagnostic Test
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- VERIFY THE DTC IS ACTIVE
- If any CAN Communication DTCs are present, perform the diagnostics for them first before continuing with this diagnostic procedure.NOTE:
This DTC must be active for the results of this test to be valid.
- Perform any Technical Service Bulletins (TSBs) that may apply.
- Turn the ignition on.
- With the scan tool, record and erase the DTCs.
- Cycle the ignition switch from off to on.
- With the scan tool, read the DTCs.
Is the DTC active at this time?
Yes
- Go To 2
No
- Perform the ABS-INTERMITTENT CONDITION TEST. Refer to ABS INTERMITTENT CONDITION .
- If any CAN Communication DTCs are present, perform the diagnostics for them first before continuing with this diagnostic procedure.
- CHECK IF DTCM DTCS ARE PRESENT
- With the scan tool, read the DTCM DTCs.
Are there any DTCM DTCs present?
Yes
- Perform the appropriate diagnostic procedures. Refer to DIAGNOSTIC CODE INDEX, DTCM .
No
- Using the schematics as a guide, check the Anti-lock Brake System (ABS) Module pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the Anti-Lock Brake System (ABS) Module in accordance with the Service Information. Refer to MODULE, ANTI-LOCK BRAKE SYSTEM (ABS), REMOVAL .
- Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
- With the scan tool, read the DTCM DTCs.