LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Rubicon, Automatic Trans >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating & Air Conditioning (Service Information) >> Controls >> Control, A/C And Heater >> Removal

Control, A/C And Heater: Removal

WARNING:

Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

NOTE:

Take the proper precautions to protect the face of the center bezel from cosmetic damage while performing this procedure.

GC0148163Courtesy of CHRYSLER GROUP, LLC
NOTE:

ATC control shown in illustration. MTC control similar.

  1. Disconnect and isolate the negative battery cable.
  2. Remove the instrument panel center bezel (3) and place it on a workbench. Refer to BEZEL, INSTRUMENT PANEL, CENTER, REMOVAL .
  3. Remove the four screws (2 and 4) that secure the A/C-heater control (1) to the back of the center bezel and remove the control.
scientia non olet · About LEMON Manuals