LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Compass Limited >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> (Drivetrain Control Module (DTCM) - Electrical Diagnostics) - Mp >> DTC Troubleshooting >> C2502-64-Status_ECM.ETCFAILSTS TRANSM2.TRANSMISSIONFAILSTS Brake8.DSTFAILSTSBRAKE8.ESCFAILSTS Status_ECM.EMSFAILSTS GE.ELECTRICSTEERINGFAILSTS >> Diagnostic Test

Diagnostic Test

  1. CHECK FOR AN ACTIVE DTC 
    NOTE:

    DO NOT replace the DTCM if this DTC is the only DTC that is set in the DTCM. This DTC only indicates that another ECU that shares the terrain function has a problem.

    1. With the scan tool, read ALL DTCs and record on the repair order.
    2. Record the Environmental Data.
    3. With the scan tool, erase ALL DTCs.
    4. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
    5. With the scan tool, read DTCM DTCs.

      Did the DTC return?

      Yes 

      • Go To  2

      No 

  2. CHECK FOR OTHER DTCS 
    1. Ignition on, engine not running.
    2. With the scan tool, read DTCs.

      Are there any other modules setting DTCs ?

      Yes 

      NOTE:

      DTC C2502-64 only sets when the DTCM detects an implausible message from another module and is used to guide the technician to the Module in question.

      • Diagnose these DTCs in accordance with the service information.
      • Perform the DTCM VERIFICATION TEST. Refer to DTCM VERIFICATION TEST  .

      No 

      • Go To  3
  3. CHECK THE TRANSMISSION CONTROL MODULE (TCM) FOR DTCs 
    1. With the scan tool, check for TCM DTCs.

      Are any TCM DTCs present?

      Yes 

      • Diagnose the TCM DTCs in accordance with the diagnostic information. Refer to DTC INDEX .
      • Perform the DTCM VERIFICATION TEST. Refer to DTCM VERIFICATION TEST  .

      No 

      • Go To  4
  4. CHECK THE ANTI-LOCK BRAKE SYSTEM MODULE (ABS) FOR DTCs 
    1. With the scan tool, check for ABS DTCs.

      Were any ABS DTCs present?

      Yes 

      No 

      • Go To  5
  5. CHECK THE ELECTRIC POWER STEERING MODULE (EPS) FOR DTCs 
    1. With the scan tool, check for EPS and PCM DTCs.

      Were any EPS DTCs present?

      Yes 

      No 

      • Diagnose the PCM DTCs in accordance with the diagnostic information. Refer to DTC INDEX .
      • Perform the DTCM VERIFICATION TEST. Refer to DTCM VERIFICATION TEST  .