LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2016 >> Renegade Trailhawk >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Transmission Verification Test & Pre-Diagnostic Troubleshooting Procedure - C635 Dual Disc Clutch Transmission (DDCT)) >> Standard Procedure >> C635 DDCT Transmission Verification Test

C635 DDCT Transmission Verification Test

WARNING: This page is about a different car, the 2015 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

For a complete wiring diagram, refer to appropriate SYSTEM WIRING DIAGRAMS article  .

  1. Perform the following after completion of a diagnostic repair:
    1. Reconnect any disconnected components.
    2. Connect the scan tool to the Data Link Connector (DLC).
    3. With the scan tool, perform the TCM Configuration if a transmission component has been replaced, or the TCM has been replaced or flashed.
    4. With the scan tool, erase all Transmission DTCs.
    5. With the scan tool, display Transmission Temperature. Start and run the engine until the Transmission Temperature is at normal operating temperature.
    6. Check the Transmission fluid level and adjust if necessary.
    7. Road test the vehicle allowing the vehicle to shift through all gears.
    8. Check for DTCs during and after the road test.

    Were there any Diagnostic Trouble Codes (DTCs) set during the road test?

    Yes 

    • Refer to the DTC INDEX article and perform the appropriate diagnostic procedure.

    No 

    • Repair is complete.
scientia non olet · About LEMON Manuals