When Monitored

WARNING: This page is about a different car, the 2015 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

This diagnostic runs continuously when the following conditions are met:

Ignition is on or the TCM is in power-on state.
Engine is not in cranking mode.
No gearshifts are in progress.
The fluid temperature is greater than a minimum threshold.
No fluid leakage DTCs
No pump excessive shifting DTCs
No hydraulic pressure sensor DTCs
Fluid temperature is correctly computed (this means that CAN information for temperature computation are available).
A calibrated amount of time has elapsed from the time of first pump activation OR the hydraulic pressure had already become greater than minimum gear shift acceptance threshold after power-on.
The first pump activation is already achieved OR the "Accumulator Discharge" fault is not set, the electro pump is on and is not in a failure state.
Battery power supply must be greater than a calibrated value and its diagnostic has not failed.