When Monitored

WARNING: This page is about a different car, the 2015 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

This diagnostic runs continuously when the following conditions are met:

Ignition key is on and the engine is not in cranking mode.
Front Wheel Speed sensors diagnostics have not failed.
Target gear is not disengaged.
Power supply must be between 7 volts and 24 volts.
The Controller Area Network (CAN) Bus off failure is not present and the CAN communication between Transmission Control Module (TCM) and the vehicle is valid.
The clutch speed sensors diagnostic has no faults.
Main Micro Processor (MMP) supply has not failed.