LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Tires & Wheels (Service Information) >> Wheels >> Stud, Wheel >> Installation >> Front Wheel Stud

Front Wheel Stud

CAUTION:

Do not use a hammer to remove wheel studs.

  1. Install the new stud into the hub flange.
  2. Install the three washers onto the stud, then install the lug nut with the flat side of the nut against the washers.
  3. Tighten the lug nut until the stud is pulled into the hub flange. Verify that the stud is properly seated into the flange.
  4. Remove the lug nut and washers.
  5. Install the brake rotor, caliper adapter, and caliper. Refer to CALIPER, DISC BRAKE, INSTALLATION .
  6. Install the wheel and tire assembly, use new lug nut on stud or studs that were replaced.
  7. Remove the support and lower vehicle.
scientia non olet · About LEMON Manuals