Axle Bracket Bushing
Courtesy of CHRYSLER GROUP, LLC
- Start the bushing in the axle bracket.
- Install the Bushing Remover/Installer (special tool #9948, Remover/Installer, Bushing) through the bushing and bracket using the following:
- (special tool #9948-3, Nut, Special) Nut (1)
- (special tool #9948-4, Installer, Bushing) Driver (2)
- (special tool #9948-5, Spacer) Spacer (3)
- (special tool #9948-1, Receiver) Receiver (4)
- Press the bushing (5) into the axle bracket (6).
- Remove tools and install the upper suspension arm. Refer to ARM, UPPER CONTROL, INSTALLATION .