Actuator, Stabilizer Bar: Installation: Installation
WARNING:
The disconnecting stabilizer bar unit (3) is not serviced separately from the bar (2). Do not disassemble this unit from the stabilizer bar.
NOTE:
The stabilizer links, stabilizer bar retainers/ bushings, stabilizer bar actuator (1) and the stabilizer bar (2) are serviceable. The new bar consists of the disconnecting unit (3) attached as an assembly to the bar.
- Install the actuator (1) to the disconnecting unit (3). Tighten the bolts to 45 N.m (37 ft. lbs.).NOTE:
The seal must be clean and intact in the electrical connector (5) when reconnecting to the actuator (1).
- Reconnect the electronic actuator electrical connector (5) for the disconnecting stabilizer bar (2).
- Remove the supports and lower the vehicle.
- Using a scan tool program the new stabilizer bar to the vehicle.