LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> Steering >> Steering Linkage >> Steering System >> Linkage >> End, Tie Rod >> Installation >> Tie Rod End

Tie Rod End

NOTE:

All views typical.

Fig 1: Identifying Toe Link Tie Rod Adjustment
GC0131159Courtesy of CHRYSLER GROUP, LLC
  1. Thread the tie rod end in the tube.
  2. Insert the tie rod in the steering knuckle.
  3. Install the ball stud nut (3) and tighten to 85 N.m (63 ft. lbs.).
  4. Position the tie rod clamp (2) and tighten to 46 N.m (34 ft. lbs.).
  5. Install the tire and wheel assembly.
  6. Remove the supports and lower the vehicle.
  7. Set the toe. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals