Diagnostic Test

VERIFY ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, read ORC DTC.
  NOTE:
  Make sure the battery is fully charged.
  
  Does the scan tool display active B223B-VEHICLE CONFIGURATION MISMATCH DTC?
  
  Yes
  - Go To 2
  No
  - Perform the AIRBAG SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE .
COMPARE STORED VIN IN THE TIPM AND ORC
1. With the scan tool in ORC select More Options select ECU Details, compare Original VIN and current VIN.
2. With the scan tool, read and record the VIN that is stored in the ORC.
  Does the stored VIN match the current VIN?
  
  Yes
  
  WARNING:
  Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
  
  WARNING:
  If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.
  - Replace the ORC in accordance with the service information. Refer to MODULE, OCCUPANT RESTRAINT CONTROLLER .
  - Perform the AIRBAG SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Replace or reprogram the TIPM in accordance with the Service Information. Refer to MODULE, TOTALLY INTEGRATED POWER (TIPM) .
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .