LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> Restraints >> Seat Belts >> Occupant Restraint Controller (Orc) - DTCS B1204 To B1C39 >> Diagnosis And Testing >> B1204-Passenger Airbag Indicator Circuit Low >> Diagnostic Test

Diagnostic Test

CHECK FOR ACTIVE DTC 

NOTE:

The Cluster performs internal tests on the Airbag Lamp during each ignition cycle.

  1. With the scan tool, erase DTCs.
  2. Turn the ignition off, wait 10 seconds, then turn the ignition on.
  3. Wait for the Cluster to perform the bulb check.
  4. With the scan tool, read DTCs.

    Is the DTC active?

    Yes 

    • Replace the Cluster in accordance with the Service Information. Refer to REMOVAL for procedure.
    • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .

    No 

    • Test complete.
scientia non olet · About LEMON Manuals