LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating & Air Conditioning (Service Information) >> Plumbing >> Oil, Refrigerant >> Standard Procedure >> Standard Procedure - Refrigerant Oil Level >> Compressor Oil Drain Procedure

Compressor Oil Drain Procedure

CAUTION:

Be certain to adjust the refrigerant system oil level when replacing an A/C compressor. Failure to properly drain and measure the refrigerant oil from the A/C compressor can prevent the A/C system from operating as designed and cause serious compressor damage.

The A/C compressor is filled with refrigerant oil from the factory. Use the following procedure to drain and measure refrigerant oil from the A/C compressor.

  1. Drain all of the refrigerant oil from the old A/C compressor into a clean measured container.
  2. Drain all of the refrigerant oil from the new A/C compressor into a clean measured container.
  3. Refill the new A/C compressor with the same amount of refrigerant oil that was drained out of the old compressor. Use only clean refrigerant oil of the type recommended for the A/C compressor in the vehicle.
  4. Install the new A/C compressor onto the engine. Refer to COMPRESSOR, A/C, INSTALLATION .
scientia non olet · About LEMON Manuals