LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating & Air Conditioning (Service Information) >> Plumbing >> Drier, A/C Receiver >> Removal >> Removal

Drier, A/C Receiver: Removal: Removal

WARNING:

Review the warnings and cautions for this system before performing the procedure. Failure to follow these instructions may result in serious injury or death.

CAUTION:

The A/C receiver/drier must be replaced if an internal failure of the A/C compressor has occurred. Failure to replace the A/C receiver drier can cause serious damage to the replacement A/C compressor.

Fig 1: Receiver/Drier
GC0131704Courtesy of CHRYSLER GROUP, LLC
NOTE:

Illustration shown with A/C condenser removed from vehicle for clarity.

  1. Disconnect and isolate the negative battery cable.
  2. Recover the refrigerant from the refrigerant system. Refer to PLUMBING, STANDARD PROCEDURE .
  3. Remove the grille. Refer to GRILLE, REMOVAL .
  4. Remove the bolt (3) that secures the A/C receiver/drier (1) to the right side A/C condenser (2).
  5. Disconnect the A/C receiver/drier from the A/C condenser and remove and discard the O-ring seals.
  6. Install plugs in, or tape over the opened receiver/drier fittings and the condenser ports.
scientia non olet · About LEMON Manuals