LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating & Air Conditioning (Service Information) >> Controls >> Transducer, A/C Pressure >> Installation >> Installation

Transducer, A/C Pressure: Installation: Installation

NOTE:

Use only the specified O-ring as it is made of special material for R-134a. Use only refrigerant oil of the type required for the A/C compressor.

Fig 1: Removing/Installing A/C Pressure Transducer
GC0082715Courtesy of CHRYSLER GROUP, LLC
NOTE:

Typical A/C pressure transducer and refrigerant line shown in illustration.

  1. Lubricate a new O-ring seal (4) with clean refrigerant oil and install it onto the refrigerant line fitting (3).
  2. Install the A/C pressure transducer (2) onto either the A/C liquid line or A/C discharge line, depending on engine application. Tighten the A/C pressure transducer securely.
  3. Connect the wire harness connector (1) to the A/C pressure transducer.
  4. Reconnect the negative battery cable.
scientia non olet · About LEMON Manuals