LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (NV241 Or Transfer Case (Service Information)) >> Installation >> Installation

Section 3 (NV241 Or Transfer Case (Service Information)): Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Align and seat transfer case on transmission. Be sure transfer case input gear splines are aligned with transmission output shaft. Align splines by rotating transfer case rear output shaft yoke if necessary. Do not install any transfer case attaching nuts until the transfer case is completely seated against the transmission.
  2. Install and tighten transfer case attaching nuts. Tighten nuts to 30-41 N.m (20-30 ft. lbs.).
  3. Install rear crossmember.
  4. Remove jack stand from under transmission.
  5. Align and connect propeller shafts. Refer to SHAFT, DRIVE, FRONT, INSTALLATION and SHAFT, DRIVE, REAR, INSTALLATION .
  6. Connect vacuum harness and vent hose.
  7. Connect shift rod to transfer case lever or floor shift arm. Use channel lock style pliers to press rod back into lever grommet.
  8. Adjust shift linkage, if necessary.
  9. Fill transfer case with recommended transmission fluid and install fill plug.
  10. Install skid plate, if equipped. Refer to PLATE, SKID, FUEL TANK, INSTALLATION , PLATE, SKID, TRANSFER CASE, INSTALLATION or PLATE, SKID, TRANSMISSION, INSTALLATION .
  11. Lower vehicle
scientia non olet · About LEMON Manuals