LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Cooling System) >> Accessory Drive >> TENSIONER, Belt >> Installation >> 3.6L

TENSIONER, Belt: Installation: 3.6L

WARNING: This page is about a different variant/trim than selected.
Fig 1: Drive Belt Tensioner, Hydraulic Tensioner & Bolts
GC0153984Courtesy of CHRYSLER GROUP, LLC
  1. Position the tensioner arm onto the engine front cover. Tighten bolt (1) to 33 N.m (24 ft. lbs.).
  2. Align the hydraulic belt tensioner strut to the engine front cover and install the bolt (4). Tighten bolt to 22.5 N.m (16.6 ft. lbs.).
  3. Install drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
scientia non olet · About LEMON Manuals