LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Cooling System) >> Accessory Drive >> Pulley, Idler >> Installation >> 2.8L

Pulley, Idler: Installation: 2.8L

WARNING: This page is about a different variant/trim than selected.
Fig 1: Drive Belt, Lifting Bracket, Idler Pulley & Bolt
GC0148194Courtesy of CHRYSLER GROUP, LLC
  1. Install lower idler pulley (2). Tighten bolt to 45 N.m (33 ft. lbs.).
  2. Install the upper idler pulley (4). Tighten bolt to 45 N.m (33 ft. lbs.).
  3. Install the serpentine belt (1). Refer to BELT, SERPENTINE, INSTALLATION .
  4. Connect the negative battery cable.
scientia non olet · About LEMON Manuals