Belt, Serpentine: Removal: 2.8L

WARNING: This page is about a different variant/trim than selected.

Fig 1: Engine Lifting Bracket & Bolts

Courtesy of CHRYSLER GROUP, LLC

CAUTION:

Do not let the tensioner arm snap back to the freearm position, severe damage may occur to the tensioner.

Disconnect the negative battery cable.
Remove bolts (2) and the engine lifting bracket (1).

Fig 2: Drive Pin & Tensioner
Courtesy of CHRYSLER GROUP, LLC
Using a suitable tool, rotate accessory drive belt tensioner (1) until holes on arm and base are aligned.
Insert pin (2) into hole to lock tensioner in place.
Remove the serpentine belt.