Diagnostic Test

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, read DTCs and record on the repair order.
  Is the DTC active or pending?
  
  Yes
  - Go To 2
  No
  - Perform the INTERMITTENT DTC diagnostic procedure. Refer to INTERMITTENT CONDITION . .
ENGINE OIL PRESSURE SENSOR
1. Turn the ignition off.
2. Replace the Oil Pressure Sensor in accordance with the Service Information. Refer to SENSOR, OIL PRESSURE, REMOVAL .
3. Turn the ignition on.
4. With the scan tool, erase DTCs in the PCM.
5. Turn the ignition off for at least three minutes.
6. Turn the ignition on.
7. Monitor the scan tool for at least two minutes.
8. With the scan tool, read DTCs.
  Is the DTC active or pending?
  
  Yes
  - Go To 3
  No
  - Repair complete.
  - Perform the PCM VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST . .
POWERTRAIN CONTROL MODULE
1. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors between the Oil Pressure Sensor and the Powertrain Control Module (PCM).
2. Look for any chafed, pierced, pinched, or partially broken wires.
3. Look for broken, bent, pushed out or corroded terminals.
4. Perform any Service Bulletins that may apply.
  Were any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the PCM VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST . .
  No
  - Replace the Powertrain Control Module (PCM) in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL .
  - Perform the PCM VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST . .