Diagnostic Test

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, read the DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Go To 2
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE HEADLAMP SWITCH
NOTE:
This DTC is set when the BCM detects a voltage value from the Headlamp Switch indicating that either Auto-headlamp or Fog Lamp function is being requested on a vehicle not equipped with those options.
1. Turn the ignition off.
2. Visually inspect the Headlamp Switch for the Auto-headlamp and Fog Lamp icons.
  Is the Headlamp Switch correct for the options present on the vehicle?
  
  Yes
  - Go To 3
  No
  - Replace the Headlamp Switch in accordance with the Service Information. Refer to SWITCH, HEADLAMP, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
RESTORE THE VEHICLE CONFIGURATION
1. Turn the ignition on.
2. With the scan tool, Restore Vehicle Configuration.
3. Turn the ignition off.
4. Turn the ignition on.
5. With the scan tool, read the DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Replace the BCM in accordance with the Service Information. Refer to MODULE, BODY CONTROL, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Test Complete.