Diagnostic Test

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

TEST FOR INTERMITTENT CONDITION
NOTE:
Check for any TSB(s) related to the condition. If a TSB applies, perform the procedure outlined in the TSB before continuing.
1. Turn the ignition on.
  NOTE:
  Make sure the battery voltage is between 10.0 and 16.0 volts.
2. With the scan tool, read the module status.
  NOTE:
  Check the BCM for any active CAN hardware DTCs, perform DTC before proceeding.
  
  Does the scan tool indicate that the module is active on the bus?
  
  Yes
  - The no response condition is not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring for chafed, pierced, pinched, and partially broken wires and the wiring harness connectors for broken, bent, pushed out, and corroded terminals.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Go To Step 2
CHECK THE (A925) FUSED B(+) CIRCUIT FOR AN OPEN OR SHORT

Fig 1: Checking Fused B(+) Circuit For An Open Or Short
Courtesy of CHRYSLER GROUP, LLC

NOTE:
Leave the scan tool

connected

and on the initial network screen.
1. Turn the ignition off.
2. Disconnect the Passenger Door Module C3 harness connector.
3. Using a 12-volt test light connected to ground, check the (A925) Fused B(+) circuit.
  Does the test light illuminate brightly?
  
  Yes
  - Go To Step 3
  No
  - Repair the open or short in the (A925) Fused B(+) circuit.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
CHECK THE (Z922) GROUND CIRCUIT FOR AN OPEN

Fig 2: Checking Ground Circuit For An Open
Courtesy of CHRYSLER GROUP, LLC
1. Using a 12-volt test light connected to 12 volts check the (Z922) Ground circuit.
  Does the test light illuminate brightly?
  
  Yes
  - Go To Step 4
  No
  - Repair the open in the (Z922) Ground circuit.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
CHECK THE CAN IHS BUS VOLTAGE AT THE MODULE
1. Turn the ignition on.
2. Using a DVOM measure the voltage of the (D214) CAN IHS Bus (125K) (-) circuit at the Passenger Door Module C3 harness connector and compare to Service Information. Refer to COMMUNICATION, OPERATION .
3. Using a DVOM measure the voltage of the (D213) CAN IHS Bus (125K) (+) circuit at the Passenger Door Module C3 harness connector and compare to Service Information. Refer to COMMUNICATION, OPERATION .
  Do the voltages found indicate the CAN IHS Bus is active, when compared to Service Information?
  
  Yes
  - Replace the Passenger Door Module in accordance with the service information.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Repair the open in the (D213) or (D214) CAN IHS Bus (125K) circuit. Inspect the connector for damage.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .