LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 ((Telematics Gateway Module - Electrical Diagnostics)) >> DTC Troubleshooting >> B143A-12-Microphone 1 - Circuit Short To Battery >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FOR AN ACTIVE DTC 
    NOTE:

    Verify the connection of the inside rearview mirror harness connector.

    1. Ignition on, engine not running.
    2. With the scan tool, read the DTCs.

      Does the scan tool display: B143A-12-MICROPHONE 1 - CIRCUIT SHORT TO BATTERY as active?

      Yes 

      • Go To  2

      No 

      • Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  2. CHECK THE INSIDE REARVIEW MIRROR 
    1. Turn the ignition off.
    2. Disconnect the Inside Rearview Mirror harness connector.
    3. Ignition on, engine not running.
    4. Wait 10 seconds.
    5. With the scan tool, read the active DTCs.

      Does the scan tool display: B143A-12-MICROPHONE 1 - CIRCUIT SHORT TO BATTERY as active?

      Yes 

      • Go To  3

      No 

      • Replace the Inside Rearview Mirror in accordance with the Service Information.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  3. CHECK THE (X712) MICROPHONE 1 IN (+) CIRCUIT FOR A SHORT TO VOLTAGE 
    1. Turn the ignition off.
    2. Disconnect the Radio connector.
    3. Ignition on, engine not running.
    4. Measure the voltage between the (X712) Microphone 1 IN (+) circuit and ground.

      Is there any voltage present?

      Yes 

      • Repair the short to voltage in the (X712) Microphone 1 IN (+) circuit.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

      No 

      • Go To  4
  4. CHECK THE (X792) MICROPHONE 1 IN (-) CIRCUIT FOR A SHORT TO VOLTAGE 
    1. Measure the voltage between the (X712) Microphone 1 IN (+) circuit and ground.

      Is there any voltage present?

      Yes 

      • Repair the short to voltage in the (X792) Microphone 1 IN (-) circuit.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST  .

      No 

      • Replace the Radio in accordance with the Service Information.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST  .
scientia non olet · About LEMON Manuals