Pump, Windshield Washer: Removal: Headlamp
WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the negative cable from the battery.
- Siphon the washer fluid from the washer reservoir into a clean container for reuse.
- Remove the washer reservoir from the cooling module. Refer to RESERVOIR, WINDSHIELD WASHER, REMOVAL .
- Pull lightly outward on the top of the washer pump/motor housing (1), away from the washer reservoir to disengage the top of the motor from the receptacle in the reservoir.
- Using hand pressure, firmly grasp and pull the washer pump upward far enough to disengage the pump inlet nipple from the rubber grommet seal/filter screen in the reservoir. Care must be taken not to damage the reservoir.
- Remove the rubber grommet seal/filter screen from the pump mounting hole in the washer reservoir and discard.