Diagnostic Test
WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
- ACTIVE DTC NOTE:
Diagnose any Brake Pedal Position Sensor DTCs in the ABS/ESP Module before continuing.
NOTE:For vehicle communication problems, use the scan tool to refer to the Network Review Screen. The screen depicts a high level view of the vehicle network. Fault and problem areas appear in red. Selecting any of the network components allows access to the source of the problem.
- Ignition on, engine not running.
- With the scan tool, select View PCM DTCs.
Is the DTC Active at this time?
Yes
- Go To 2
No
- Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
- ABS MODULE DTCS PRESENT
- With the scan tool continue reading DTCs.
Are there any DTCs set in the ABS Module?
Yes
- Refer to DIAGNOSIS AND TESTING and perform the diagnostic procedure.
No
- Replace and program the Powertrain Control Module (PCM) in accordance with the service information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL .
- Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
- With the scan tool continue reading DTCs.