Diagnostic Test

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

ACTIVE DTC
NOTE:
An incorrect temperature reading from the Cool Temperature Sensor or Ambient Temperature Sensor could cause this DTC to set. Verify that both temperature sensors are reading correctly before proceeding with this test.

NOTE:
Diagnose and repair any other DTCs set in the PCM before proceeding with this test.
1. Turn the ignition on.
2. With the scan tool, clear DTCs in the Powertrain Control Module (PCM).
3. Start the engine and allow it to reach operating temperature.
  WARNING:
  When the engine is operating, do not stand in direct line with the fan. Do not put your hands near the pulleys, belts or fan. Do not wear loose clothing. Failure to follow these instructions may result in possible serious or fatal injury.
4. With the scan tool, select View DTCs.
  Is the DTC Active at this time?
  
  Yes
  - Go To 2
  No
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
CHECK THE (F942) FUSED IGNITION RUN/START CIRCUIT
1. Turn the ignition off.
2. Disconnect the PCM C1 harness connector.
  CAUTION:
  Do not probe the PCM harness connectors. Probing the PCM harness connectors will damage the PCM terminals resulting in poor terminal to pin connection. Install the GPEC Diagnostic Adaptor to perform the diagnosis.
3. Connect the (special tool #10436, Adapter, GPEC Diagnostic).
4. With a 12-volt test light connected to ground, probe the (F942) Fused Ignition Run/Start circuit at the GPEC Adaptor.
5. Perform the above check with the Ignition key in the off lock position, Ignition on, engine not running position and during cranking.
6. Wiggle the related wire harness while probing the special tool with the test light to try to interrupt the circuit.
  Does the test light illuminate brightly?
  
  Yes
  - Go To 3
  No
  - Repair the open or excessive resistance in the (F942) Fused Ignition Run/Start circuit. Inspect the related fuse, if the fuse is open check the circuit for a short to ground.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
CHECK THE PCM GROUND CIRCUITS
1. Turn the ignition off.
2. With a 12-volt test light connected to 12 volts, probe the PCM Ground circuits at the GPEC Adaptor.
3. Wiggle the related wire harness while probing the special tool with the test light to try to interrupt the circuit.
  Does the test light illuminate brightly?
  
  Yes
  - Go To 4
  No
  - Repair the open or excessive resistance in the Ground circuits.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
POWERTRAIN CONTROL MODULE (PCM)
1. Verify that the PCM is operating at the latest software version available.
2. Perform any Technical Service Bulletins that may apply.
  Were any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Replace and program the Powertrain Control Module (PCM) in accordance with the service information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL .
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .