Diagnostic Test

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

PCM PROGRAMMED WITH INCORRECT SOFTWARE

Ignition on, engine not running.
Program the PCM in accordance with the Service Information. Refer to PCM/ECM REPROGRAMMING - GAS .
Start the engine.
Allow the engine to reach normal operating temperature.
With a scan tool, select read the active DTCs.
Does the scan tool display P1400-AFTERMARKET CALIBRATION DETECTED/WARRANTY VOID?

Yes
- Replace and program the Powertrain Control Module (PCM) in accordance with the service information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL .
- Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
No
- The Powertrain Control Module (PCM) has been successfully programmed. Test is complete.
- Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .