LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (3.6L Engine (Service Information)) >> Engine Block >> Rod, Piston And Connecting >> Standard Procedure >> Connecting Rod Side Clearance >> Dial Indicator

Dial Indicator

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Measuring Connecting Rod Side Clearance
GC0081625Courtesy of CHRYSLER GROUP, LLC
  1. Mount Dial Indicator Set (special tool #C-3339A, Set, Dial Indicator) to a stationary point on the engine. Locate the probe perpendicular to and resting against the connecting rod cap being checked.
  2. Move the connecting rod all the way to the rear of its travel.
  3. Zero the dial indicator.
  4. Move the connecting rod forward to the limit of travel and read the dial indicator. Compare the measured side clearance to the. Refer to ENGINE SPECIFICATIONS  .
  5. Repeat this procedure for each connecting rod. Rotate the crankshaft for connecting rod accessibility.
scientia non olet · About LEMON Manuals