Diagnostic Test
WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
MILEAGE NOT PROGRAMMED IN THE POWERTRAIN CONTROL MODULE (PCM)
- Ignition on, engine not running.
- With a scan tool, clear DTCs.
- Using the scan tool, program the vehicle mileage into the Powertrain Control Module (PCM).
- Start the engine and allow it to reach normal operating temperature.
- With a scan tool, select View DTCs.
Is the status Active for this DTC?
Yes
- Replace and program the Powertrain Control Module (PCM) in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL .
- Perform the PCM VERIFICATION Test. Refer to PCM VERIFICATION TEST .
No
- Test complete.
- Perform the PCM VERIFICATION Test. Refer to PCM VERIFICATION TEST .