Theory Of Operation
| EVAP SYSTEM COMPONENTS | |
|---|---|
| CALL OUT | DESCRIPTION |
| 1 | Filter |
| 2 | ESIM Switch |
| 3 | Evaporative Canister |
| 4 | Fuel Tank Vent (Check Valve) |
| 5 | Control Valve |
| 6 | Inlet Check Valve |
| 7 | Fuel Tank Pressure Sensor |
| 8 | To Purge System |
| 9 | Fuel Fill Tube |
The Evaporative Purge Monitor tests the integrity of the hoses/tube between the throttle body/intake and the fuel tank. The monitor is a two stage test and runs only after the Evaporative system passes the small leak test. Stage one is non-intrusive. The Powertrain Control Module (PCM) monitors the purge vapor ratio and the Evaporative System Integrity Monitor (ESIM) switch closed ratio. If the purge vapor ratio is above a calculated value, the monitor passes. If the ESIM switch closed ratio is greater than calculated value when purge flow is greater than a minimum value, the monitor passes. Stage two is an intrusive test and runs only if stage one does not pass. The PCM commands the purge solenoid to flow at a specified rate to force the purge vapor ratio to update. The ratio is compared to a calibrated specification. If it is less than specified, a one trip failure is recorded. This test can detect if the purge hose is off, obstructed or the purge valve is not operational.