Diagnostic Test
WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
CONFIGURE THE INTRUSION TRANSCEIVER MODULE
- With the scan tool under miscellaneous functions, perform the initialization procedure for the Intrusion Transceiver Module (ITM).
- Turn the ignition off and remove the key from the ignition.
- Lock and close all doors to allow the VTSS to go from pre-arm to armed status and wait one minute.
- Disarm the VTSS.
- With the scan tool, read ITM DTCs.
Does the scan tool display this DTC as active?
Yes
- Replace the Intrusion Transceiver Module in accordance with the Service Information. Refer to MODULE, INTRUSION, REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Test complete.
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .