Diagnostic Test
WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT DRIVER DOOR SWITCH ASSEMBLY FOR DAMAGE NOTE:
Diagnose and repair all LIN Bus related DTCs before performing this test procedure.
- Cycle the ignition off.
- Inspect the Driver Window/Door Lock Switch for damage.
Is the switch assembly damaged?
Yes
- Replace the Driver Window/Door Lock Switch in accordance with the Service Information.
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Go To 2
- INSPECT FOR OBJECT OR SUBSTANCE CAUSING MIRROR ADJUST SWITCH TO STAY OR STICK IN A PUSHED POSITION
- Inspect the Mirror Adjust switch for anything that would cause it to stay or stick in a pushed position.
Is anything present that would cause the Mirror Adjust switch to stay or stick in a pushed position?
Yes
- Repair as necessary.
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Go To 3
- Inspect the Mirror Adjust switch for anything that would cause it to stay or stick in a pushed position.
- TEST FOR INTERMITTENT CONDITION
- Cycle the ignition on.
- With the scan tool, record and erase the DTCs.
- Press and release either Mirror Select switch.
- Operate the Mirror Adjust switch in all positions several times and then wait 30 seconds.
- With the scan tool, read the DTCs.
Does the scan tool display this DTC as active?
Yes
- Replace the Driver Window/Door Lock Switch in accordance with the Service Information. Refer to SWITCH, POWER WINDOW, REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .