LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (2.4L Engine (Service Information)) >> Lubrication >> Control Valve, Oil Intake >> Removal >> Front Solenoid 1/1

Front Solenoid 1/1

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Oil Pressure Sensor
GC0082437Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect negative battery cable.
  2. Remove engine cover.
  3. Rotate hose clamp out of way.
  4. Disconnect oil pressure sensor electrical connector.
  5. Remove oil pressure sensor.
  6. Disconnect variable valve timing solenoid electrical connector.
    Fig 2: Solenoid Mounting Bolt
    GC0082438Courtesy of CHRYSLER GROUP, LLC
  7. Remove variable valve timing solenoid mounting bolt.
    Fig 3: Solenoid Mounting Tab 1/1
    GC0082439Courtesy of CHRYSLER GROUP, LLC
  8. Pull solenoid straight out of cylinder head.
scientia non olet · About LEMON Manuals