LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (2.4L Engine (Service Information)) >> Lubrication >> Control Valve, Oil Intake >> Installation >> Front Solenoid 1/1

Front Solenoid 1/1

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Solenoid Mounting Tab 1/1
GC0082439Courtesy of CHRYSLER GROUP, LLC
  1. Solenoid for front location 1/1. Note mounting tab location is different between front and rear solenoids.
    Fig 2: Solenoid Mounting Bolt
    GC0082438Courtesy of CHRYSLER GROUP, LLC
  2. Install solenoid into cylinder head.
  3. Install mounting bolt and tighten to 12 N.m (9 ft. lbs.).
    Fig 3: Oil Pressure Sensor
    GC0082437Courtesy of CHRYSLER GROUP, LLC
  4. Install oil pressure sensor.
  5. Connect electrical connector to oil pressure sensor.
  6. Connect electrical connector to Variable valve timing solenoid.
  7. Connect negative battery cable.
  8. Install engine cover.
scientia non olet · About LEMON Manuals