LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (2.4L Engine (Service Information)) >> Cylinder Head >> Spring(S), Valve >> Removal >> Cylinder Head On

Cylinder Head On

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Valve Removal
GC0121430Courtesy of CHRYSLER GROUP, LLC
  1. Remove cylinder head cover . Refer to COVER(S), CYLINDER HEAD, REMOVAL  .
  2. Remove camshafts . Refer to CAMSHAFT, ENGINE, REMOVAL  .
  3. Mark valve tappet location for assembly.
  4. Remove valve tappets.
  5. Rotate crankshaft until piston is at TDC on compression.
  6. With air hose attached to adapter tool installed in spark plug hole, apply 90-120 psi air pressure.
    CAUTION:

    Care must be taken not to damage the tappet bore or engine damage may result.

  7. Using metric valve keeper tool (1) such as Snap-on® GA317 (or equivalent), and remove valve spring keepers and retainer.
  8. Remove valve spring(s).
  9. Remove valve stem seal(s) by a using valve stem seal tool.
scientia non olet · About LEMON Manuals